![]() The hole in which the speaker wire fits best on the wire stripper is the speaker’s gauge. You can check the gauge of your speaker wire by looking at the markings on the wire or using a wire stripper. ![]() AWG stands for the American Wire Gauge (AWG). For instance, an 18AWG wire is thinner than a 12AWG one. Gauge refers to the wire’s thickness, and the higher the number, the thinner the wire, and a lower gauge rating indicates that the wire is thick. Using scissors to cut and strip the speaker wire can also do the job, but you risk damaging the wires.Īlso, the extension wire should be the same gauge as the original speaker wire for the best audio output once the wire has been extended. You will need a good wire stripper and quality wire cutters to help you measure your speaker wire gauge and cut the speaker correctly. You can even use a multimeter (Amazon) to check for any residual power on the speaker. Therefore, carefully review your speaker’s warranty before extending the wire.īefore extending the speaker wire, ensure the speaker is disconnected from the receiver or amplifier to avoid being electrocuted. ![]() ![]() Remember that most speaker manufacturers advise against extending speaker wires since, if done incorrectly, it can lead to audio dropouts or even short-circuit the speaker.Īlso, cutting the speaker wire to extend it will likely nullify your warranty if the warranty period has yet to elapse. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |